1.1 This test method covers a direct aqueous injection procedure for the gas-liquid chromatographic determination of phenols, cresols, and mono- and di-chlorophenols in water.
1.2 The precision and bias of the test method has been calculated from the results of interlaboratory analyses of three master solutions, each containing phenol, p-cresol, p-chlorophenol, 3,5-dichlorophenol.
1.3 The test method may be applied to waste water or concentrates that contain more than 1 mg/L of phenolic compounds. Therefore, for a comparison with Test Methods D1783, see Appendix X1.
1.4 The analyst should recognize that precision statements provided in and may not apply to waters of other matrices.
1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 3.
More ASTM standard pdf
ASTM D5805-00(2014)
Standard Test Methods for Rubber -- Determination of Carbon Black in Masterbatches
$27.00 $54.00
ASTM A249/A249M-16
Standard Specification for Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes
$29.00 $58.00
ASTM D1519-95(2014)
Standard Test Methods for Rubber Chemicals -- Determination of Melting Range
$26.00 $52.00