• ASTM D2700-14

ASTM D2700-14

Standard Test Method for Motor Octane Number of Spark-Ignition Engine Fuel

ASTM International, 10/01/2014

Publisher: ASTM

File Format: PDF

$47.00$94.00


Published:01/10/2014

Pages:58

File Size:1 file , 1000 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This laboratory test method covers the quantitative determination of the knock rating of liquid spark-ignition engine fuel in terms of Motor octane number, including fuels that contain up to 25 % v/v of ethanol. However, this test method may not be applicable to fuel and fuel components that are primarily oxygenates.2 The sample fuel is tested in a standardized single cylinder, four-stroke cycle, variable compression ratio, carbureted, CFR engine run in accordance with a defined set of operating conditions. The octane number scale is defined by the volumetric composition of primary reference fuel blends. The sample fuel knock intensity is compared to that of one or more primary reference fuel blends. The octane number of the primary reference fuel blend that matches the knock intensity of the sample fuel establishes the Motor octane number.

1.2 The octane number scale covers the range from 0 to 120 octane number, but this test method has a working range from 40 to 120 octane number. Typical commercial fuels produced for automotive spark-ignition engines rate in the 80 to 90 Motor octane number range. Typical commercial fuels produced for aviation spark-ignition engines rate in the 98 to 102 Motor octane number range. Testing of gasoline blend stocks or other process stream materials can produce ratings at various levels throughout the Motor octane number range.

1.3 The values of operating conditions are stated in SI units and are considered standard. The values in parentheses are the historical inch-pounds units. The standardized CFR engine measurements continue to be in inch-pound units only because of the extensive and expensive tooling that has been created for this equipment.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For more specific hazard statements, see Section 8, 13.4.1, 14.5.1, 15.6.1, Annex A1, A2.2.3.1, A2.2.3.3(6) and (9), A2.3.5, X3.3.7, X4.2.3.1, X4.3.4.1, X4.3.9.3, X4.3.12.4, and X4.5.1.8.

More ASTM standard pdf

ASTM F2973-21

ASTM F2973-21

Standard Specification for Insulating Lifting Links for Load Lifting Equipment Working Near Energized Power Lines

$26.00 $52.00

ASTM F3118-15

ASTM F3118-15

Standard Consumer Safety Specification for Infant Inclined Sleep Products

$32.00 $65.00

ASTM E1851-15

ASTM E1851-15

Standard Test Method for Electromagnetic Shielding Effectiveness of Durable Rigid Wall Relocatable Structures

$27.00 $54.00

ASTM F3101-15

ASTM F3101-15

Standard Specification for Unsupervised Public Use Outdoor Fitness Equipment

$44.00 $89.00