• ASTM D2774-12

ASTM D2774-12

Standard Practice for Underground Installation of Thermoplastic Pressure Piping

ASTM International, 02/01/2012

Publisher: ASTM

File Format: PDF

$31.00$62.00


Published:01/02/2012

Pages:7

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice governs procedures and references ASTM specifications for underground installation of thermoplastic pressure piping, 63-in. (1372-mm) nominal size and smaller. It is beyond the scope of this practice to describe these procedures in detail since it is recognized that significant differences exist in their implementation depending on kind and type of pipe material, pipe size and wall thickness, soil conditions, and the specific end use.

1.1.1 This practice assumes that over the range of anticipated operating conditions, including maximum external loading and minimum internal pressure, the soil/pipe system will offer sufficient structural stability to resist possible excessive diametrical deformation, or even collapse. In cases, particularly with large diameter thinner-walled pipe, for which the validity of this assumption may be in question, the selection of pipe and recommended installation conditions shall be determined by a qualified engineer.

1.1.2 Specific pipe characteristics and end-use requirements shall dictate addition to, or modification of the procedures stated or referenced herein.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Sections 10 and 11.

More ASTM standard pdf

ASTM D6884-03

ASTM D6884-03

Standard Practice for Installation of Articulating Concrete Block (ACB) Revetment Systems

$25.00 $50.00

ASTM D6896-03e1

ASTM D6896-03e1

Standard Test Method for Determination of Yield Stress and Apparent Viscosity of Used Engine Oils at Low Temperature

$24.00 $48.00

ASTM C1002-04

ASTM C1002-04

Standard Specification for Steel Self-Piercing Tapping Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs

$30.00 $60.00

ASTM B137-95(2004)

ASTM B137-95(2004)

Standard Test Method for Measurement of Coating Mass Per Unit Area on Anodically Coated Aluminum

$26.00 $52.00