Your shopping cart is empty!
ASTM International, 05/10/1998
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:10/05/1998
Pages:3
File Size:1 file , 28 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement. For changes to this Standard since the last issue, refer to the Summary of Changes Section at the end of the Standard.
1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency and drying rate.
1.3 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S customary units may be approximate.
Standard Specification for Flexible Fiberoptic Bronchoscopes (Withdrawn 2001)
$25.00 $50.00
Standard Practice for Surface Preparation and Structural Adhesive Bonding of Precured, Nonmetallic Composite Facings to Structural Core for Flat Shelter Panels
$29.00 $58.00
Standard Specification for Wrought High-Strength Low-Alloy Steel Butt-Welding Fittings
$30.00 $60.00
Standard Specification for Thermoplastic Elastomeric (TPE) Gasket Materials for Drain, Waste, and Vent (DWV), Sewer, Sanitary and Storm Plumbing Systems