Your shopping cart is empty!
ASTM International, 07/01/2017
Publisher: ASTM
File Format: PDF
$22.00$44.00
Published:01/07/2017
Pages:3
File Size:1 file , 65 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a lubricant suitable for facilitating the insertion and positioning of preformed elastomeric compression seals in prepared voids (usually contraction joints) in concrete pavement.
1.2 The requirements of the lubricant are based on the performance of the lubricant as measured by its solids content, homogeneity, consistency, and drying rate.
1.3 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of U.S. customary units may be approximate.
1.4 The following precautionary caveat pertains only to the test method portion, Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Electric-Fusion-Welded Steel Pipe for High-Pressure Service at Moderate Temperatures
$30.00 $60.00
Standard Test Methods for Flexible Treated Sleeving Used for Electrical Insulation
$31.00 $62.00
Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes
Standard Specification for Electric-Fusion-Welded Steel Pipe for Atmospheric and Lower Temperatures