Your shopping cart is empty!
ASTM International, 04/01/2021
Publisher: ASTM
File Format: PDF
$37.00$75.00
Published:01/04/2021
Pages:39
File Size:1 file , 870 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''These test methods cover procedures for testing hookup wire.
1.2''For the purposes of these test methods, hookup wire insulation includes all components of the insulation system used on single insulated conductors or an assembly of single insulated conductors such as a cable bundle and harness or flat ribbon cable. The insulating materials include not only the primary insulation over the conductor, but also insulating jackets over shielded constructions.
1.3''These test methods and their locations are as follows:
''
Section
Axial Stability (Longitudinal Change) After Thermal Exposure
20
Bondability of Insulation to Potting Compounds
18
Capacitance
9 to 11
Cold Bend Test
25
Concentricity
Crush Resistance
19
Dielectric Breakdown Voltage
5
Dimensions
14
Dry-arc Tracking
28
Dynamic Cut-through
21
Fluid Immersion
22
High Temperature Shock
23
Insulation-Continuity Proof Tests
12
Insulation Resistance
6
Partial Discharge (Corona) Inception and Extinction Voltage
24
Relative Thermal Life and Temperature Index
13
Strip Force
26
Surface Resistance
Tensile Properties
16
Vertical Flame
17
Vertical Flame Test A
18.5 (Test Method D8354)
Vertical Flame Test B
17.6 ''' 17.11.4
Voltage Rating of Hook-Up Wire
Annex A1
Voltage Withstand Test
8
Wet Arc-tracking
27
1.4''The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.5''This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.6''Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.
1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see
Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis
$26.00 $52.00
Standard Guide for Evaluating Cleaning Performance of Ceramic Tile Cleaners
$30.00 $60.00
Standard Practice for Sampling Yarn for Testing
Standard Terminology for Additive Manufacturing Technologies, (Withdrawn 2015)
$25.00 $50.00