Your shopping cart is empty!
ASTM International, 10/01/2016
Publisher: ASTM
File Format: PDF
$21.00$42.00
Published:01/10/2016
Pages:4
File Size:1 file , 65 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice covers the storage testing of aerosol products.
1.2 There are two major types of storage tests that may be performed on aerosol products:
1.2.1 Live Storage Tests, where the valves are actuated and the determinations are made at relatively frequent intervals (the purpose being to simulate consumer use of aerosol dispensers), and
1.2.2 Dead Storage Tests, performed to simulate warehouse storage conditions when shelf-life information is sought.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 4.
Standard Test Method for Measuring Heat Transfer Rate Using a Thin-Skin Calorimeter
$31.00 $63.00
Standard Test Method for Dropping Point of Lubricating Grease Over Wide Temperature Range
$27.00 $54.00
Standard Practice for Sectional Repair of Existing Gravity Flow, Non-Pressure Pipelines and Conduits by Pushed or Pulled-In-Place Installation of Cured-In-Place Thermosetting Resin Pipe (CIPP)
Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster
$34.00 $68.00
