ASTM D3161/D3161M-13

Standard Test Method for Wind-Resistance of Steep Slope Roofing Products (Fan-Induced Method)

ASTM International, 06/15/2013

Publisher: ASTM

File Format: PDF

$26.00$52.00

Description

Published:15/06/2013

Pages:4

File Size:1 file , 68 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the procedure for evaluating the wind resistance of many discontinuous, air permeable, steep slope roofing products that results from the product's rigidity, with or without contribution from sealant or other adhesive to help hold down the leading edge of the tabs, or mechanical interlocking, with or without contribution from sealant or other adhesive to help hold down the leading edge of the tabs, or any combination thereof. The products are applied to a test panel in accordance with the manufacturer's instructions and tested at a 2:12 (17 %) slope, or at the lowest slope permitted by those instructions.

1.2 This method evaluates wind resistance using a fan-induced procedure, delivering a stream of air across the exposed surface of the test specimens. This method does not measure structural performance, and does not provide a measure of uplift resistance. Consequently, this method is not applicable to continuous, non-permeable roof systems or coverings (such as membranes or mechanically-seamed metal roof panels).

1.3 This test method is limited to steep slope roofing product applied with a maximum exposure of 410 mm (16 in.).

Note 1-This test method was formerly titled “Wind Resistance of Asphalt Shingles (Fan-Induced Method)” but was revised to acknowledge that the method is applicable to many other steep slope roofing products and has been used to evaluate the wind resistance of those products for many years by several testing and certification laboratories, Products that have been tested by this method, in addition to asphalt shingles, include polymer-based shingles, fiber-cement shingles, concrete tiles, clay tiles, metal shingles, and photovoltaic shingles. The terms steep slope roofing products, or product, are used throughout this standard to include all of these types of steep slope roofing products.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D7268-14

Standard Performance Specification for Seamless Knit Garments Including Intimates and Swimwear

$30.00 $60.00

ASTM E1356-08(2014)

ASTM E1356-08(2014)

Standard Test Method for Assignment of the Glass Transition Temperatures by Differential Scanning Calorimetry (Withdrawn 2023)

$30.00 $60.00

ASTM E2040-08(2014)

ASTM E2040-08(2014)

Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers

$26.00 $52.00

ASTM B584-09

Standard Specification for Copper Alloy Sand Castings for General Applications

$30.00 $60.00