Your shopping cart is empty!
ASTM International, 06/01/2013
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/06/2013
Pages:2
File Size:1 file , 71 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers acetone (99.5 % grade).
1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 1.5 and 4.1.
1.5 This specification specifies the use of a U.S. Occupational Safety and Health Administration (OSHA)-designated hazardous chemical, acetone. For hazard information and guidance see the supplier's Material Safety Data Sheet.
Standard Specification for Low Volatile Organic Compound (VOC) Corrosion-Inhibiting Adhesive Primer for Aluminum Alloys to Be Adhesively Bonded
$31.00 $62.00
Standard Test Method for Rust-Preventing Characteristics of Inhibited Mineral Oil in the Presence of Water
$30.00 $60.00
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets
$29.00 $58.00
Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests (Withdrawn 2016)
