Your shopping cart is empty!
ASTM International, 10/01/2015
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/10/2015
Pages:5
File Size:1 file , 260 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the estimation of the hydrogen content (mass percent) of aviation gasolines and aircraft turbine and jet engine fuels.
1.2 This test method is empirical and is applicable to liquid hydrocarbon fuels that conform to the requirements of specifications for aviation gasolines or aircraft turbine and jet engine fuels of types Jet A, Jet A-1, Jet B, JP-4, JP-5, JP-7, and JP-8.
Note 1: The procedure for the experimental determination of hydrogen in petroleum fractions is described in Test Methods D1018 and D3701.
Note 2: The estimation of the hydrogen content of a hydrocarbon fuel is justifiable only when the fuel belongs to a well-defined class for which a relationship among the hydrogen content and the distillation range, density, and aromatic content has been derived from accurate experimental measurements on representative samples of that class. Even in this case, the possibility that the estimates may be in error by large amounts for individual fuels should be recognized. The fuels used to establish the correlation presented in this test method are defined by the following specifications:
Fuel
Specification
Aviation gasolines
D910
Aircraft turbine and jet engine fuels
JP-4 and JP-5
MIL-T-5624
JP-6
MIL-J-25056 (Obsolete)
JP-7
MIL-T-38219
Jet A
D1655
Miscellaneous hydrocarbons
No. 2 Diesel fuel
Kerosine distillates (similar to Jet A)
Miscellaneous (includes thinners, gasoline fractions, and unidentified blends)
Special production fuels (commercial products of nearly pure hydrocarbons and special high-temperature fuels (HTF) produced for Air Force tests.
Pure hydrocarbons
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Specimens and Testing Conditions for Testing Polyethylene (PE) Pipe Butt Fusions Using Tensile and Hydrostatic Test Methods
$28.00 $57.00
Standard Terminology Relating to Roofing and Waterproofing
$29.00 $58.00
Standard Specification for Polyetheretherketone (PEEK) Polymers for Surgical Implant Applications
$34.00 $68.00
Standard Specification for Seamless Red Brass Pipe, Standard Sizes
$25.00 $50.00