• ASTM D3419-12

ASTM D3419-12

Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

ASTM International, 04/01/2012

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/04/2012

Pages:4

File Size:1 file , 99 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used and its plasticity.

Note 1 - The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This practice assumes the use of reciprocating screw injection molding machines.

Note 2 - This standard and ISO 10724 address the same subject matter, but differ in technical content.

More ASTM standard pdf

ASTM D7668-14a

ASTM D7668-14a

Standard Test Method for Determination of Derived Cetane Number (DCN) of Diesel Fuel Oils -- Ignition Delay and Combustion Delay Using a Constant Volume Combustion Chamber Method

$33.00 $67.00

ASTM C1448/C1448M-05(2010)

ASTM C1448/C1448M-05(2010)

Standard Specification for Non-Asbestos Fiber-Cement Conduit

$30.00 $60.00

ASTM D5034-95(2001)

ASTM D5034-95(2001)

Standard Test Method for Breaking Strength and Elongation of Textile Fabrics (Grab Test)

$30.00 $60.00

ASTM D5710-95

ASTM D5710-95

Standard Specification for Trinidad Lake Modified Asphalt

$27.00 $54.00