• ASTM D3511/D3511M-15

ASTM D3511/D3511M-15

Standard Test Method for Pilling Resistance and Other Related Surface Changes of Textile Fabrics: Brush Pilling Tester

ASTM International, 07/01/2015

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/07/2015

Pages:5

File Size:1 file , 200 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the propensity of a fabric to form pills from fuzz under test conditions intended to simulate normal wear using the brush pilling tester. This procedure is generally intended to be used for upholstery, automotive, luggage and heavy duty uniform fabrics because it is highly abrasive. This does not however preclude it from being used for other types of fabrics. If unsure, comparison tests should be performed to ensure that this test method replicates pilling on the final product.

Note 1: For other test methods for the pilling resistance of textiles, refer to Test Methods D3512, D3514, and D4970.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM F2050-16

ASTM F2050-16

Standard Consumer Safety Specification for Hand-Held Infant Carriers

$30.00 $60.00

ASTM F1640-21

ASTM F1640-21

Standard Guide for Selection and Use of Contact Materials for Foods to Be Irradiated

$23.00 $46.00

ASTM D8256-20

ASTM D8256-20

Standard Test Method for Evaluation of Automotive Engine Oils for Inhibition of Deposit Formation in the Sequence VH Spark-Ignition Engine Fueled with Gasoline and Operated Under Low-Temperature, Light-Duty Conditions

$57.00 $115.00

ASTM C1007-20

ASTM C1007-20

Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories

$22.00 $44.00