Your shopping cart is empty!
ASTM International, 05/01/2014
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:01/05/2014
Pages:6
File Size:1 file , 97 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the use of gas chromatography to determine the amount of diesel fuel in used engine lubricating oil. This test is limited to SAE 30 oil. The diesel fuel diluent is analyzed at concentrations up to 12 mass %.
1.2 This test method is limited to gas chromatographs equipped with flame ionization detectors and temperature programmable ovens.
1.3 There is some overlap of the boiling ranges of diesel fuel and SAE 30 engine oils. Moreover, the boiling range of SAE 30 oils from various sources can vary appreciably. As a result, the calibration can be altered by as much as 2 %, in terms of fuel dilution. When testing unknown or mixed brands of used engine oil, it should be realized that the precision of the method may be poorer than the precision obtained when calibrating with a new oil representative of the used oil being tested.
1.4 The values stated in SI units are to be regarded as the standard. The values stated in inch-pound units are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
Standard Test Method for Determination of the Maximum Flocculation Ratio and Peptizing Power in Residual and Heavy Fuel Oils (Optical Detection Method)
$28.00 $56.00
Standard Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants
$52.00 $104.00
Standard Specification for Helmets Used for Downhill Mountain Bicycle Racing
$24.00 $48.00
Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter
$31.00 $63.00