Your shopping cart is empty!
ASTM International, 10/01/2003
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/10/2003
Pages:3
File Size:1 file , 28 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of the volatiles content, in weight percent of composite material prepregs. This standard focuses on composites with thermosetting resins that tend to lose a few percent of the matrix mass when heated due to loss of both retained water and low molecular weight matrix constituents that volatilize during heating.
1.2 Use of this test method is limited to maximum temperature of circulating air ovens (approximately 300°C).
1.3 Use of this test method is limited to temperatures below which the matrix flows from the reinforcement.
1.4 The values stated in SI units are to be regarded as standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.
Standard Specifications For Preformed Expansion Joint Fillers For Concrete Paving And Structural Construction1 Nonextruding And Resilient Nonbituminous Types
$21.00 $43.20
Specification for Enclosures and Servicing Units for Tests Above and Below Room Temperature
$111.00 $223.67
Standard Test Method for Apparent Viscosity Of Plastisols And Organosols At Low Shear Rates By Brookfield Viscometer
$26.00 $52.00
Specification for High Conductivity Composite Aluminum-Steel-Copper Strip for Electron Tubes
$144.00 $289.00