• ASTM D3641-15

ASTM D3641-15

Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials

ASTM International, 05/01/2015

Publisher: ASTM

File Format: PDF

$31.00$62.00


Published:01/05/2015

Pages:10

File Size:1 file , 250 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers the general principles to be followed when injection molding test specimens of thermoplastic molding and extrusion materials. This practice is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and to set up uniform methods of reporting these conditions. The exact conditions required to prepare suitable specimens will vary for each plastic material. Any requirements or recommendations in the material specification that differ from this standard take precedence over those in this standard. Always consult the referenced material document for specimen preparation. If no referenced document exists, then consult the material supplier for specimen preparation guidance and note such in the test report.

1.2 The methodology presented assumes the use of reciprocating screw injection molding machines.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: This practice is equivalent to the following parts of ISO 294: Plastics-Injection Moulding of Test Specimens of Thermoplastic Materials; 294-1: Part 1-General Principles and Multipurpose Test Specimens (ISO Type A Mould) and Bars (ISO Type B Mould); ISO 294-2: Part 2-Small Tensile Bars (ISO Type C Mould); ISO 294-3: Part 3-Plates (ISO Type D Moulds).

More ASTM standard pdf

ASTM B940-05(2014)

ASTM B940-05(2014)

Standard Practice for Testing Non-Chromate Coatings on Zinc and Cadmium Surfaces

$26.00 $52.00

ASTM F1415-92(2000)

ASTM F1415-92(2000)

Standard Specification for Pulse Oximeters (Withdrawn 2005)

$29.00 $58.00

ASTM F2465/F2465M-05(2011)e1

ASTM F2465/F2465M-05(2011)e1

Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems

$25.00 $50.00

ASTM D1384-00e1

ASTM D1384-00e1

Standard Test Method for Corrosion Test for Engine Coolants in Glassware

$23.00 $47.00