• ASTM D3649-23

ASTM D3649-23

Standard Practice for High-Resolution Gamma-Ray Spectrometry of Water

ASTM International, 06/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/06/2023

Pages:8

File Size:1 file , 370 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers the measurement of gamma-ray emitting radionuclides in water by means of gamma-ray spectrometry. It is applicable to nuclides emitting gamma-rays with energies greater than 45 keV. For typical counting systems and sample types, activity levels of about 40 Bq are easily measured and sensitivities as low as 0.4 Bq are found for many nuclides. Count rates in excess of 2000 counts per second should be avoided because of electronic limitations. High count rate samples can be accommodated by dilution, by increasing the sample to detector distance, or by using digital signal processors.
1.2 This practice can be used for either quantitative or relative determinations. In relative counting work, the results may be expressed by comparison with an initial concentration of a given nuclide which is taken as 100 %. For quantitative measurements, the results may be expressed in terms of known nuclidic standards for the radionuclides known to be present. This practice can also be used just for the identification of gamma-ray emitting radionuclides in a sample without quantifying them. General information on radioactivity and the measurement of radiation has been published (1,2).2 Information on specific application of gamma spectrometry is also available in the literature (3-5). See also the referenced ASTM Standards in 2.1 and the related material section at the end of this standard.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitation prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E1515-00

ASTM E1515-00

Standard Test Method for Minimum Explosible Concentration of Combustible Dusts

$29.00 $58.00

ASTM G157-98(2005)

ASTM G157-98(2005)

Standard Guide for Evaluating the Corrosion Properties of Wrought Iron- and Nickel-Based Corrosion Resistant Alloys for the Chemical Process Industries

$29.00 $58.00

ASTM D3437-11

ASTM D3437-11

Standard Practice for Sampling and Handling Liquid Cyclic Products

$30.00 $60.00

ASTM F18-64(2000)

ASTM F18-64(2000)

Standard Specification and Test Method for Evaluation of Glass-to-Metal Headers Used in Electron Devices

$29.00 $58.00