1.1 This practice is intended for use in determining the geometrical dimensions of rubber products and specimens for physical tests. This practice describes procedures for determining length, width, thickness, diameter, and circumference. This practice does not cover sampling of materials or products, or locations where a sample is to be taken.
1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as a standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any other way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.
More ASTM standard pdf
ASTM E1603/E1603M-11
Standard Practice for Leakage Measurement Using the Mass Spectrometer Leak Detector or Residual Gas Analyzer in the Hood Mode
$29.00 $58.00
ASTM F788/F788M-06
Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
$29.00 $58.00
ASTM E2117-06(2011)
Standard Guide for Identification and Establishment of a Quality Assurance Program for Medical Transcription (Withdrawn 2020)
$30.00 $60.00