• ASTM D3828-16a(2021)

ASTM D3828-16a(2021)

Standard Test Methods for Flash Point by Small Scale Closed Cup Tester

ASTM International, 07/01/2021

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/07/2021

Pages:10

File Size:1 file , 200 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''These test methods cover procedures for flash point tests, within the range of '''30'''''C to 300'''''C, of petroleum products and biodiesel liquid fuels, using a small scale closed cup tester. The procedures may be used to determine, whether a product will or will not flash at a specified temperature (flash/no flash Method A) or the flash point of a sample (Method B). When used in conjunction with an electronic thermal flash detector, these test methods are also suitable for flash point tests on biodiesels such as fatty acid methyl esters (FAME).

1.2''The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3''This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Warning statements appear throughout. See also the Material Safety Data Sheets for the product being tested.

1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3153-87(2002)

ASTM D3153-87(2002)

Standard Test Method for Recoatability of Water-Emulsion Floor Polishes

$26.00 $52.00

ASTM C507-18

ASTM C507-18

Standard Specification for Reinforced Concrete Elliptical Culvert, Storm Drain, and Sewer Pipe

$29.00 $58.00

ASTM C1697-10

ASTM C1697-10

Standard Specification for Blended Supplementary Cementitious Materials

$29.00 $58.00

ASTM D2756-85(1998)

ASTM D2756-85(1998)

Standard Test Method for Weight Loss of Electrical Insulating Varnishes

$27.00 $54.00