Your shopping cart is empty!
ASTM International, 12/01/2004
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/12/2004
Pages:9
File Size:1 file , 130 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover the determination of the proportion of ethylene and propylene units in ethylene-propylene copolymers (EPM) and ethylene-propylenediene terpolymers (EPDM) over the range from 35 to 85 mass % ethylene. Four test methods are needed to encompass the variety of commercial polymers that contain additives or polymerized diene units that interfere with the various infrared peaks. Except when interferences are present, all four test methods should give similar results. The test methods appear in the following order:
1.1.1 Pressed Film Test Methods
1.1.2 Cast Film Test Methods
1.2 These test methods are not applicable to oil-extended EPDM unless the oil is first removed in accordance with Test Method D.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Welded and Seamless Steel Pipe Piles
$29.00 $58.00
Standard Specification for Piping Fittings of Wrought Carbon Steel and Alloy Steel for Moderate and High Temperature Service
$30.00 $60.00
Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)
$25.00 $50.00
Standard Test Method for Cleanliness and Compatibility of Residual Fuels by Spot Test
$26.00 $52.00