• ASTM D3916-08

ASTM D3916-08

Standard Test Method for Tensile Properties of Pultruded Glass-Fiber-Reinforced Plastic Rod

ASTM International, 03/01/2008

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/03/2008

Pages:5

File Size:1 file , 80 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method describes a procedure for determining the tensile properties of pultruded, glass-fiber-reinforced thermosetting plastic rod of diameters ranging from 3.2 mm (1/8 in.) to 25.4 mm (1 in.). Little test specimen preparation is required; however, reusable aluminum tab grip adapters (Fig. 1) of appropriate size are required to prevent premature failure of the specimens at the grips.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Note 3 and Note 4.

Note 1-There is no known ISO equivalent to this test method.

More ASTM standard pdf

ASTM E1990-98

ASTM E1990-98

Standard Guide for Performing Evaluations of Underground Storage Tank Systems for Operational Conformance with 40 CFR, Part 280 Regulations

$29.00 $58.00

ASTM Volume 04.05:2009

ASTM Volume 04.05:2009

ASTM Book of Standards Volume 4.05: Construction: Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry

$107.00 $215.31

ASTM D5887-09

ASTM D5887-09

Standard Test Method for Measurement of Index Flux Through Saturated Geosynthetic Clay Liner Specimens Using a Flexible Wall Permeameter

$30.00 $60.00

ASTM B134/B134M-08

ASTM B134/B134M-08

Standard Specification for Brass Wire

$30.00 $60.00