• Your shopping cart is empty!

  • ASTM D3923-23

ASTM D3923-23

Standard Practices for Detecting Leaks in Reverse Osmosis and Nanofiltration Devices

ASTM International, 01/01/2023

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/01/2023

Pages:4

File Size:1 file , 75 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These practices cover detecting leaks in which there is a direct communication between the feed or concentrate, or both, and the permeate. Several types of leaks are possible with the various configurations of reverse-osmosis (RO) and nanofiltration (NF) devices.
1.2 Types of Leaks: 
1.2.1 With hollow-fiber devices, feed or concentrate leakage, or both, into the permeate stream by leaks through the tube sheet and past the tube sheet O-ring are possible. "Leaks" caused by broken fibers are not covered by these practices.
1.2.2 With spiral-wound devices, leaks may occur through damage of the membrane surface itself by punctures or scratches, by glue-line failure, and by O-ring leaks on product tube interconnectors.
1.2.3 With tubular devices, leaks due to membrane damage, tube end seal leaks, and leaks from broken tubes or product headers are possible.
1.3 Three leak test practices are given as follows:
  Sections Practice A-Tube Sheet and O-Ring Leak Test for Hollow
 Fiber Devices 8 to 9 Practice B-Vacuum Test for Spiral Wound Devices 10 to 12 Practice C-Dye Test for Spiral Wound and Tubular Devices 13 to 18
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D2290-16

ASTM D2290-16

Standard Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe

$29.00 $58.00

ASTM D3625-96(2001)

ASTM D3625-96(2001)

Standard Practice for Effect of Water on Bituminous-Coated Aggregate Using Boiling Water

$25.00 $50.00

ASTM A506-16

ASTM A506-16

Standard Specification for Alloy and Structural Alloy Steel, Sheet and Strip, Hot-Rolled and Cold-Rolled

$28.00 $56.00

ASTM D4101-06a

ASTM D4101-06a

Standard Specification for Polypropylene Injection and Extrusion Materials

$33.00 $67.00