Your shopping cart is empty!
ASTM International, 06/01/2007
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/06/2007
Pages:3
File Size:1 file , 69 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of the flash point of liquids in which the specimen and the air/vapor mixture above it are approximately in temperature equilibrium.
1.2 This test method is limited to a temperature range from 0 to 110°C (32 to 230°F).
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard should be used to measure and describe the properties of material, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Analysis of Methyl Tert-Butyl Ether (MTBE) by Gas Chromatography
$30.00 $60.00
Standard Test Methods for Surface and Interfacial Tension of Solutions of Surface-Active Agents
$26.00 $52.00
Standard Test Method for Adenosine Triphosphate (ATP) Content of Microorganisms in Fuel, Fuel/Water Mixtures, and Fuel Associated Water
$29.00 $58.00
Standard Guide for Evaluating Water Leakage of Building Walls
$41.00 $83.00