• ASTM D396-15

ASTM D396-15

Standard Specification for Fuel Oils

ASTM International, 01/01/2015

Publisher: ASTM

File Format: PDF

$32.00$65.00


Published:01/01/2015

Pages:11

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification (see Note 1) covers grades of fuel oil intended for use in various types of fuel-oil-burning equipment under various climatic and operating conditions. These grades are described as follows:

1.1.1 Grades No. 1 S5000, No. 1 S500, No. 2 S5000, and No. 2 S500 are middle distillate fuels for use in domestic and small industrial burners. Grades No. 1 S5000 and No. 1 S500 are particularly adapted to vaporizing type burners or where storage conditions require low pour point fuel.

1.1.2 Grades No. 4 (Light) and No. 4 are heavy distillate fuels or middle distillate/residual fuel blends used in commercial/industrial burners equipped for this viscosity range.

1.1.3 Grades No. 5 (Light), No. 5 (Heavy), and No. 6 are residual fuels of increasing viscosity and boiling range, used in industrial burners. Preheating is usually required for handling and proper atomization.

Note 1: For information on the significance of the terminology and test methods used in this specification, see Appendix X1.

Note 2: A more detailed description of the grades of fuel oils is given in X1.3.

1.2 This specification is for the use of purchasing agencies in formulating specifications to be included in contracts for purchases of fuel oils and for the guidance of consumers of fuel oils in the selection of the grades most suitable for their needs.

1.3 Nothing in this specification shall preclude observance of federal, state, or local regulations which can be more restrictive.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 3: The generation and dissipation of static electricity can create problems in the handling of distillate burner fuel oils. For more information on the subject, see Guide D4865.

More ASTM standard pdf

ASTM E1343-90(1997)e1

ASTM E1343-90(1997)e1

Standard Test Method for Molecular Weight Cutoff Evaluation of Flat Sheet Ultrafiltration Membranes

$29.00 $58.00

ASTM E833-00

ASTM E833-00

Standard Terminology of Building Economics

$29.00 $58.00

ASTM D6067-96(2003)

ASTM D6067-96(2003)

Standard Guide for Using the Electronic Cone Penetrometer for Environmental Site Characterization

$30.00 $60.00

ASTM D6056-96(2001)

ASTM D6056-96(2001)

Standard Test Method for Determining Concentration of Airborne Single-Crystal Ceramic Whiskers in the Workplace Environement by Transmission Electron Microscopy

$30.00 $60.00