• ASTM D3973-85(2011)

ASTM D3973-85(2011)

Standard Test Method for Low-Molecular Weight Halogenated Hydrocarbons in Water

ASTM International, 05/01/2011

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2011

Pages:5

File Size:1 file , 98 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the analysis of drinking water. It is also applicable to many environmental and waste waters when adequate validation is included.

1.2 This test method covers the determination of halomethanes, haloethanes, and some related extractable organohalides amenable to gas chromatographic measurement. The applicable concentration range for trihalomethanes is from 1 to 200 μg/L. Detection limits depend on the compound, matrix, and on the characteristics of the gas chromatographic system.

1.3 For compounds not specifically included in the precision and bias section the analyst should validate the test method by collecting precision and bias data on actual samples.

1.4 Confirmation of component identities is obtained by observing retention times using gas chromatographic columns of different polarities. When concentrations are sufficiently high (>50 μg/L) confirmation with halogen specific detectors or gas chromatography/mass spectrometry (GC/MS) may be used. Confirmation of purgeable compounds at levels down to 1 μg/L can be obtained using Test Method D3871 with GC/MS detection.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.

More ASTM standard pdf

ASTM D6701-21

ASTM D6701-21

Standard Test Method for Determining Water Vapor Transmission Rates Through Nonwoven and Plastic Barriers

$26.00 $52.00

ASTM D5580-21

ASTM D5580-21

Standard Test Method for Determination of Benzene, Toluene, Ethylbenzene, p/m-Xylene, o-Xylene, C9 and Heavier Aromatics, and Total Aromatics in Finished Gasoline by Gas Chromatography

$29.00 $58.00

ASTM A960/A960M-19a

ASTM A960/A960M-19a

Standard Specification for Common Requirements for Wrought Steel Piping Fittings

$30.00 $60.00

ASTM D7468-16

ASTM D7468-16

Standard Test Method for Cummins ISM Test

$41.00 $83.00