1.1 This test method covers the determination of viscosity of catalyzed chemical grouts with a rotational viscometer (laboratory method), over the range from 1.0 mPa·s to 1000 mPa·s (1.0 to 1000 cP).
1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.2.1 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose of obtaining the data, special purpose studies, or any consideratons for the user's objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.3 The values stated in SI units are the standard. Other units provided in parentheses are for the convenience of the user.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
More ASTM standard pdf
ASTM A751-14a
Standard Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
$24.00 $48.00
ASTM A888-11
Standard Specification for Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste, and Vent Piping Applications
$47.00 $94.00
ASTM A781/A781M-14b
Standard Specification for Castings, Steel and Alloy, Common Requirements, for General Industrial Use
$33.00 $67.00
ASTM D3825-90(1995)
Standard Test Method for Dynamic Surface Tension by the Fast-Bubble Technique
$31.00 $62.00