1.1 This test method covers the field procedure for performing an in situ instantaneous change in head (slug) test.
1.2 This test method is used in conjunction with an analytical procedure such as Test Method D4104 to data analysis and to determine aquifer properties.
1.3 Units-The values stated in either SI Units or inch-pound units are to be regarded separately as standard. The values in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.4.1 The procedures used to specify how data are collected/recorded and calculated in the standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user's objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of these test methods to consider significant digits used in analysis methods for engineering data.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
More ASTM standard pdf
ASTM D5641-94(2001)e1
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
$26.00 $52.00
ASTM F3200-18a
Standard Terminology for Driverless Automatic Guided Industrial Vehicles
$30.00 $60.00
ASTM D6636-01(2011)
Standard Test Method for Determination of Ply Adhesion Strength of Reinforced Geomembranes
$26.00 $52.00
ASTM D5670-95(2004)e1
Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry
$30.00 $60.00