Your shopping cart is empty!
ASTM International, 10/01/2015
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/10/2015
Pages:14
File Size:1 file , 340 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
Test Method A-Dumbbell and Straight Section Specimens
Test Method B-Cut Ring Specimens
Note 1: These two different methods do not produce identical results.
1.2 The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Conducting Cyclic Potentiodynamic Polarization Measurements for Localized Corrosion Susceptibility of Iron-, Nickel-, or Cobalt-Based Alloys
$29.00 $58.00
Standard Test Method for Determining the Contact Bounce Time of a Membrane Switch
$25.00 $50.00
ASTM Standards Related to Environmental Site Characterization, 2nd Edition
$110.00 $221.42
Standard Test Method for Determination of Edge Performance of Composite Wood Products Under Surfactant Accelerated Moisture Stress
$26.00 $52.00
