Your shopping cart is empty!
ASTM International, 11/01/2016
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:01/11/2016
Pages:14
File Size:1 file , 350 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
''
Test Method A'''Dumbbell and Straight Section Specimens
Test Method B'''Cut Ring Specimens
Note 1:''These two different methods do not produce identical results.
1.2''The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Salt Water Proofness of Insulating Varnishes Over Enamelled Magnet Wire
$26.00 $52.00
Standard Practice for Geomembrane Seam Evaluation by Vacuum Chamber
$21.00 $42.00
Standard Test Method for Electrical Resistivity of Membrane-Pavement Systems
$30.00 $60.00
Standard Test Method for Assessing Middle Distillate Fuel Storage Stability by Oxygen Overpressure