Your shopping cart is empty!
ASTM International, 10/01/2016
Publisher: ASTM
File Format: PDF
$48.00$97.00
Published:01/10/2016
Pages:45
File Size:1 file , 1.3 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice describes general procedures and equipment for automatically obtaining samples of liquid petroleum and petroleum products, crude oils, and intermediate products from the sample point into the primary container. This practice also provides additional specific information about sample container selection, preparation, and sample handling. If sampling is for the precise determination of volatility, use Practice D5842 (API MPMS Chapter 8.4) in conjunction with this practice. For sample mixing and handling, refer to Practice D5854 (API MPMS Chapter 8.3). This practice does not cover sampling of electrical insulating oils and hydraulic fluids.
1.2 Table of Contents:
Section
INTRODUCTION
Scope
1
Referenced Documents
2
Terminology
3
Significance and Use
4
PART I-GENERAL
Representative Sampling Components
5
Design Criteria
6
Automatic Sampling Systems
7
Sampling Location
8
Mixing of the Flowing Stream
9
Proportionality
10
Sample Extractor Grab Volume
11
Containers
12
Sample Handling and Mixing
13
Control Systems
14
Sample System Security
15
System Proving (Performance Acceptance Tests)
16
Performance Monitoring
17
PART II-CRUDE OIL
Crude Oil
18
PART III-REFINED PRODUCTS
Refined Products
19
KEYWORDS
Keywords
20
ANNEXES
Calculations of the Margin of Error based on Number of Sample Grabs
Annex A1
Theoretical Calculations for Selecting the Sampler Probe Location
Annex A2
Performance Criteria for Portable Sampling Units
Annex A3
Profile Performance Test
Annex A4
Sampler Acceptance Test Data
Annex A5
APPENDIXES
Design Data Sheet for Automatic Sampling System
Standard Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
$49.00 $98.00
Standard Specification for Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength, General Use
$31.00 $62.00
Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases
$25.00 $50.00
Standard Specification for Common Requirements for Steel Flanges, Forged Fittings, Valves, and Parts for Piping Applications
$29.00 $58.00
