• ASTM D4242-91(1995)e1

ASTM D4242-91(1995)e1

Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders

ASTM International, 01/01/1995

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/01/1995

Pages:3

File Size:1 file , 36 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method specifies a method for determining the flow characteristics of a fused thermosetting coating powder down a plane inclined at a set angle to the horizontal. The test gives an indication of the degree of melt flow that may occur during the curing of the coating powder. This characteristic contributes to the coherence of the coating, to its surface appearance and to the degree of coverage over sharp edges, however, it should not be used as the sole factor for judgment. The test acts as a useful method for checking for batch to batch variation in the behavior of a given coating powder. Correlation between the results from coating powders of differing composition is not to be expected. This method is unlikely to yield meaningful results with coating powders which have gel times of less than one minute at the test temperature (see Test Method D 4217.)

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D3766-08(2013)

ASTM D3766-08(2013)

Standard Terminology Relating to Catalysts and Catalysis

$26.00 $52.00

ASTM C1068-03

ASTM C1068-03

Standard Guide for Qualification of Measurement Methods by a Laboratory Within the Nuclear Industry

$26.00 $52.00

ASTM E2975-16

ASTM E2975-16

Standard Test Method for Calibration or Calibration Verification of Concentric Cylinder Rotational Viscometers

$29.00 $58.00

ASTM A510M-02

ASTM A510M-02

Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric]

$30.00 $60.00