• ASTM D4394-17

ASTM D4394-17

Standard Test Method for Determining In Situ Modulus of Deformation of Rock Mass Using Rigid Plate Loading Method

ASTM International, 07/01/2017

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/07/2017

Pages:11

File Size:1 file , 400 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the preparation, equipment, test procedure, and data reduction for determining in situ modulus of deformation of a rock mass using the rigid plate loading method.

1.2 This test method is designed to be conducted in an adit or small underground chamber; however, with suitable modifications it could be conducted at the surface.

1.3 This test method is usually conducted parallel or perpendicular to the anticipated axis of thrust, as dictated by the design load and to diametrically opposite surfaces.

1.4 Both instantaneous deformation and primary creep can be obtained from this test method.

1.5 Time dependent tests can be performed and are discussed briefly here but are to be reported in another standard.

1.6 Observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.6.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.8 The references appended to this standard contain further information on this test method.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. For specific precaution statements, see Section 8.

1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C563-18a

ASTM C563-18a

Standard Guide for Approximation of Optimum SO3 in Hydraulic Cement

$30.00 $60.00

ASTM D1412/D1412M-17a

ASTM D1412/D1412M-17a

Standard Test Method for Equilibrium Moisture of Coal at 96 to 97 Percent Relative Humidity and 30 oC

$29.00 $58.00

ASTM F679-21

ASTM F679-21

Standard Specification for Poly(Vinyl Chloride) (PVC) Large-Diameter Plastic Gravity Sewer Pipe and Fittings

$27.00 $54.00

ASTM F855-20

ASTM F855-20

Standard Specifications for Temporary Protective Grounds to Be Used on De-energized Electric Power Lines and Equipment

$38.00 $76.00