• ASTM D4454-85(2009)

ASTM D4454-85(2009)

Standard Test Method for Simultaneous Enumeration of Total and Respiring Bacteria in Aquatic Systems by Microscopy (Withdrawn 2015)

ASTM International, 05/01/2009

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/05/2009

Pages:3

File Size:1 file , 71 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the detection and enumeration of aquatic bacteria by the use of an acridine-orange epifluorescence direct-microscopic counting procedure. This test method is applicable to environmental waters and potable waters.

1.2 Certain types of debris and other microorganisms may fluoresce in acridine-orange stained smears.

1.3 The procedure described requires a trained microbiologist or technician who is capable of distinguishing bacteria from other fluorescing bodies on the basis of morphology when viewed at higher magnifications.

1.4 Use of bright light permits differentiation of single bacteria where reduced formazan is deposited at the polar ends.

1.5 Approximately 104 cells/mL are required for detection by this test method.

1.6 Minimal cell size which allows the detection of formazan deposits is represented by bacteria of 0.4 μm.²

1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.8 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM C754-11

ASTM C754-11

Standard Specification for Installation of Steel Framing Members to Receive Screw-Attached Gypsum Panel Products

$33.00 $67.00

ASTM F1796-09(2014)

ASTM F1796-09(2014)

Standard Specification for High Voltage Detectors -- Part 1 Capacitive Type to be Used for Voltages Exceeding 600 Volts AC

$29.00 $58.00

ASTM D6549-00

ASTM D6549-00

Standard Test Method for Determination of Cooling Characteristics of Quenchants by Cooling Curve Analysis with Agitation (Drayton Unit)

$29.00 $58.00

ASTM A960-00

ASTM A960-00

Standard Specification for Common Requirements for Wrought Steel Piping Fittings

$29.00 $58.00