• ASTM D4535-21

ASTM D4535-21

Standard Test Methods for Measurement of Thermal Expansion of Rock Using Dilatometer

ASTM International, 06/01/2021

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/06/2021

Pages:7

File Size:1 file , 190 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''These test methods cover the laboratory measurement of the one-dimensional linear thermal expansion of rocks using a dilatometer.

1.2''The methods are applicable between temperatures of 25''C to 300''C. Both bench top and confined measurement techniques are presented. Method A is used for unconfined or bench top measurements and Method B is used for confined conditions. Rocks of varying moisture content can be tested.

1.3''For satisfactory results in conformance with these test methods, the principles governing the size, construction, and use of the apparatus described in these test methods shall be followed. If the results are to be reported as having been obtained by either test method, then the pertinent requirements prescribed by that test method shall be met.

1.4''These test methods do not establish details of construction and procedures to cover all test situations that might offer difficulties to a person without technical knowledge concerning the theory of heat flow, temperature measurement, and general testing practices. Standardization of these test methods does not reduce the need for such technical knowledge.

1.5''Units'''The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

1.6''All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.6.1''The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user'''s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design.

1.7''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F3541-22

ASTM F3541-22

Standard Practice for Sectional Repair of Existing Gravity Flow, Non-Pressure Pipelines and Conduits by Pushed or Pulled-In-Place Installation of Cured-In-Place Thermosetting Resin Pipe (CIPP)

$27.00 $54.00

ASTM C1063-22

ASTM C1063-22

Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster

$34.00 $68.00

ASTM B417-22

ASTM B417-22

Standard Test Method for Apparent Density of Non-Free-Flowing Metal Powders Using the Carney Funnel

$24.00 $48.00

ASTM E2567-16a(2023)

ASTM E2567-16a(2023)

Standard Test Method for Determining Nodularity And Nodule Count In Ductile Iron Using Image Analysis

$25.00 $50.00