• ASTM D4623-05

ASTM D4623-05

Standard Test Method for Determination of In Situ Stress in Rock Mass by Overcoring Method-USBM Borehole Deformation Gage

ASTM International, 11/01/2005

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/11/2005

Pages:14

File Size:1 file , 380 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the ambient local stresses in a rock mass and the equipment required to perform in situ stress tests using a three-component borehole deformation gage (BDG). The test procedure and method of data reduction are described, including the theoretical basis and assumptions involved in the calculations. A section is included on troubleshooting equipment malfunctions. Note 1The gage used in this test method is commonly referred to as a USBM gage (U.S. Bureau of Mines three-component borehole deformation gage).

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D7320-10a

ASTM D7320-10a

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIG, Spark-Ignition Engine

$47.00 $94.00

ASTM A763-93(2004)

ASTM A763-93(2004)

Standard Practices for Detecting Susceptibility to Intergranular Attack in Ferritic Stainless Steels

$33.00 $67.00

ASTM D150-98(2004)

ASTM D150-98(2004)

Standard Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

$33.00 $67.00

ASTM A506-04

ASTM A506-04

Standard Specification for Alloy and Structural Alloy Steel, Sheet and Strip, Hot-Rolled and Cold-Rolled

$26.00 $52.00