Your shopping cart is empty!
ASTM International, 11/01/2005
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/11/2005
Pages:7
File Size:1 file , 100 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method describes procedures for measuring the energy that enters the penetrometer drill rod string during dynamic penetrometer testing of soil due to the hammer impact.
1.2 This test has particular application to the comparative evaluation of N-values obtained from the Standard Penetration Tests (SPT) of soils in an open hole as in Test Method D 1586 and Practice D 6066. This procedure may also be applicable to other dynamic penetrometer tests.
1.3 LimitationsThis test method applies to penetrometers driven from above the ground surface. It is not intended for use with down-hole hammers.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.
1.5 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to how the data can be applied in design or other uses, since that is beyond its scope. Practice D 6066 specifies how these data may be normalized.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Zinc, Tin and Cadmium Base Alloys Used as Solders
$27.00 $54.00
Standard Practice for Hayride Attractions
$49.00 $98.00
Standard Practice for Calculating Heat of Vaporization or Sublimation from Vapor Pressure Data
$23.00 $46.00
Standard Guide for Width and Length of Pressure-Sensitive Tape