Your shopping cart is empty!
ASTM International, 02/01/2013
Publisher: ASTM
File Format: PDF
$44.00$89.00
Published:01/02/2013
Pages:25
File Size:1 file , 250 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for testing crosslinked insulations and jackets for wire and cable. To determine the test to be made on the particular insulation or jacket, refer to the product specification for that type. These test methods do not apply to the class of products known as flexible cords.
1.2 In many instances the insulation or jacket cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated or jacketed wire or cable in these test methods solely to determine the relevant property of the insulation or jacket and not to test the conductor or completed cable.
1.3 The procedures appear in the following sections:
Sections
AC and DC Voltage Withstand Tests
22 to 29
Capacitance and Dissipation Factor Tests
38 to 44
Cold Bend
128
Cold Bend, Long-Time Voltage Test on Short Specimens
51 to 57
Double AC Voltage Test on Short Specimens
45 to 50
Electrical Tests of Insulation
17 to 64
Heat Distortion Test
127
Horizontal Flame Test
100 to 104
Insulation Resistance Tests on Completed Cable
30 to 37
Mineral Filler Content, Determination of
111 to 115
Ozone Resistance Test
87 to 99
Partial-Discharge Test
58 to 64
Physical Tests of Insulation and Jacket Compounds
5 to 16
Surface Resistivity Test
116 to 120
Track Resistance Test
129 to 132
U-Bend Discharge Test
121 to 125
Water Absorption Test
65 to 71
Water Absorption Test, Accelerated
72 to 86
Water Absorption Test on Fibrous Coverings
105 to 110
1.4 Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in the parentheses are for information only.
1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 4.
Standard Test Method for Abrasion Resistance of Stone Subjected to Foot Traffic
$27.00 $54.00
Standard Practice for Determining Relative Spectral Correction Factors for Emission Signal of Fluorescence Spectrometers
$28.00 $57.00
Standard Test Method for Determining Impact Resistance of New Low Slope Roof Membranes Using Steel Balls (Z8295Z)
Standard Specification for 100 Research Octane Number Test Fuel for Automotive Spark-Ignition Engines
$32.00 $64.00
