Your shopping cart is empty!
ASTM International, 01/15/2021
Publisher: ASTM
File Format: PDF
$37.00$75.00
Published:15/01/2021
Pages:24
File Size:1 file , 300 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''These test methods cover procedures for testing crosslinked insulations and jackets for wire and cable. To determine the test to be made on the particular insulation or jacket, refer to the product specification for that type. These test methods do not apply to the class of products known as flexible cords.
1.2''In many instances the insulation or jacket cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated or jacketed wire or cable in these test methods solely to determine the relevant property of the insulation or jacket and not to test the conductor or completed cable.
1.3''These test methods appear in the following sections:
Test Method
Section(s)
''
AC and DC Voltage Withstand Tests
22 to 29
Capacitance and Dissipation Factor Tests
38 to 44
Cold Bend
124
Cold Bend, Long-time Voltage Test on Short Specimens
51 to 57
Double AC Voltage Test on Short Specimens
45 to 50
Electrical Tests of Insulation
17 to 64
Heat Distortion Test
123
Horizontal Flame Test
100 (Test Method D7936)
Insulation Resistance Tests on Completed Cable
30 to 37
Mineral Filler Content, Determination of
107 to 111
Ozone Resistance Test
87 to 99
Partial-Discharge Test
58 to 64
Physical Tests of Insulation and Jacket Compounds
'''5 to 16
Surface Resistivity Test
112 to 116
Track Resistance Test
125 to 128
U-Bend Discharge Test
117 to 121
Water Absorption Test
65 to 71
Water Absorption Test, Accelerated
72 to 86
Water Absorption Test on Fibrous Coverings
'''101 to 106
1.4''Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in the parentheses are for information only.
1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 4.
1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys
$41.00 $82.00
Standard Specification for Cold-Formed Welded and Seamless Carbon Steel Structural Tubing in Rounds and Shapes
$32.00 $64.00
Standard Practice for Descaling and Cleaning Zirconium and Zirconium Alloy Surfaces
$23.00 $46.00
Standard Test Method for Chemical Composition of Gases by Mass Spectrometry
$26.00 $52.00
