• ASTM D4703-10

ASTM D4703-10

Standard Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets

ASTM International, 06/01/2010

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/06/2010

Pages:12

File Size:1 file , 160 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice covers the compression molding of thermoplastic granules and milled stock for the preparation of test specimens.

1.2 While conditions for certain materials are given, the primary source of specific conditions shall be the material specification standards for each type of material.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1 - The main body of this practice is equivalent to ISO 293-1986. Annex A1 and ISO 293-1986 differ in some details; however, specimens prepared using Annex A1, Procedure A should be equivalent to those prepared using ISO 293-1986, Cooling Method D. Specimens prepared using Annex A1, Procedure C should be equivalent to those prepared using ISO 293-1986, Cooling Method B. However, due to the greater cooling rate tolerances of the ISO standard, specimens prepared in accordance with ISO Cooling Method B may not be equivalent to Annex A1, Procedure C.

More ASTM standard pdf

ASTM D7727-11

ASTM D7727-11

Standard Practice for Calculation of Dose Equivalent Xenon (DEX) for Radioactive Xenon Fission Products in Reactor Coolant

$25.00 $50.00

ASTM C1365-06(2011)

ASTM C1365-06(2011)

Standard Test Method for Determination of the Proportion of Phases in Portland Cement and Portland-Cement Clinker Using X-Ray Powder Diffraction Analysis

$30.00 $60.00

ASTM D7775-11e1

ASTM D7775-11e1

Standard Guide for Measurements on Small Graphite Specimens

$30.00 $60.00

ASTM F2111-01a(2011)

ASTM F2111-01a(2011)

Standard Practice for Measuring Intergranular Attack or End Grain Pitting on Metals Caused by Aircraft Chemical Processes

$25.00 $50.00