• ASTM D4812-05

ASTM D4812-05

Standard Test Method for Unnotched Cantilever Beam Impact Strength of Plastics

ASTM International, 11/01/2005

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/11/2005

Pages:12

File Size:1 file , 210 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the resistance of plastics to breakage by flexural shock, as indicated by the energy extracted from standardized pendulum-type hammers, mounted in standardized machines, in breaking standard specimens with one pendulum swing. The result of this test method is reported as energy absorbed per unit of specimen width.

Note 1

The pendulum-type test instruments have been standardized in that they must comply with certain requirements, including a fixed height of hammer fall that results in a substantially fixed velocity of the hammer at the moment of impact. Pendulums of different initial energies (produced by varying their effective weights) are recommended for use with specimens of different impact strengths. Moreover, manufacturers of the equipment are permitted to use different lengths and constructions of pendulums (with resulting possible differences in pendulum rigidities (see Section ), and other differences in machine design).

1.2 The values stated in SI units are to be regarded as standard. The values given in brackets are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2

This standard and ISO 180, Method 1U, are similar in content but are not technically equivalent.

More ASTM standard pdf

ASTM F1859-12

ASTM F1859-12

Standard Specification for Rubber Sheet Floor Covering Without Backing

$25.00 $50.00

ASTM A588/A588M-01

ASTM A588/A588M-01

Standard Specification for High-Strength Low-Alloy Structural Steel with 50 ksi [345 MPa] Minimum Yield Point to 4-in. [100-mm] Thick

$26.00 $52.00

ASTM A962/A962M-01a

ASTM A962/A962M-01a

Standard Specification for Common Requirements for Steel Fasteners or Fastener Materials, or Both, Intended for Use at Any Temperature from Cryogenic to the Creep Range

$30.00 $60.00

ASTM F1797-15

ASTM F1797-15

Standard Test Method for Acoustic Emission Testing of Insulated and Non-Insulated Digger Derricks

$29.00 $58.00