Your shopping cart is empty!
ASTM International, 02/15/2015
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:15/02/2015
Pages:5
File Size:1 file , 79 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This guide provides guidelines for the identification and packaging of rolled geosynthetics by the manufacturer and for the handling and storage of geosynthetics by the end user. This guide is not to be considered as all encompassing since each project involving geosynthetics presents its own challenges and special conditions. Geosynthetic samples are often taken at manufacturer, supplier, or at the job site primarily for the purpose of conformance testing and verification. These samples should be properly labeled for identification purposes.
1.2 This guide is intended to aid manufacturers, suppliers, purchasers, and users of geosynthetics for identification, handling, and storage.
1.3 This guide is not applicable for factory fabricated panels due to a different set of identifications for the panel by the fabricator. For Fabricated Geomembrane Panels, refer to Guide D7865.
1.4 This guide is not intended for Geosynthetic Clay Liners. For GCL's, refer to Guide D5888.
1.5 This guide is also applicable to geosynthetic samples.
1.6 Each type of Geosynthetic is listed by section to address specific requirements.
Geotextiles - Section 5
Geogrids - Section 6
Geomembrane Rolls - Section 7
Geonets - Section 8
Geocomposites - Section 9
1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Determining Stability and Compatibility of Heavy Fuel Oils and Crude Oils by Heavy Fuel Oil Stability Analyzer (Optical Detection)
$32.00 $65.00
Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
$33.00 $67.00
Standard Test Method for Total Iodine Value of Drying Oils and Their Derivatives (Withdrawn 2006)
$25.00 $50.00
Standard Test Method for Percent Air Voids in Compacted Dense and Open Bituminous Paving Mixtures