• ASTM D4935-18

ASTM D4935-18

Standard Test Method for Measuring the Electromagnetic Shielding Effectiveness of Planar Materials

ASTM International, 05/01/2018

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/05/2018

Pages:11

File Size:1 file , 580 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method provides a procedure for measuring the electromagnetic (EM) shielding effectiveness (SE) of a planar material for a plane, far-field EM wave. From the measured data, near-field SE values can be calculated for magnetic (H) sources for electrically thin specimens.2,3 Electric (E) field SE values are also able to be calculated from this same far-field data, but their validity and applicability have not been established.

1.2 The measurement method is valid over a frequency range of 30 MHz to 1.5 GHz. These limits are not exact, but are based on decreasing displacement current as a result of decreased capacitive coupling at lower frequencies and on overmoding (excitation of modes other than the transverse electromagnetic mode (TEM)) at higher frequencies for the size of specimen holder described in this test method. Select any number of discrete frequencies within this range. For electrically thin, isotropic materials with frequency independent electrical properties of conductivity, permittivity, and permeability, measurements will possibly be needed at only a few frequencies as the far-field SE values will be independent of frequency. If the material is not electrically thin or if any of the parameters vary with frequency, make measurements at several frequencies within the band of interest.

1.3 This test method is not applicable to cables or connectors.

1.4 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D1322-22

ASTM D1322-22

Standard Test Method for Smoke Point of Kerosene and Aviation Turbine Fuel

$31.00 $63.00

ASTM F3357-19

ASTM F3357-19

Standard Guide for Designing Reusable Medical Devices for Cleanability

$25.00 $50.00

ASTM A587-22

ASTM A587-22

Standard Specification for Electric-Resistance-Welded Low-Carbon Steel Pipe for the Chemical Industry

$28.00 $57.00

ASTM C1784-20

ASTM C1784-20

Standard Test Method for Using a Heat Flow Meter Apparatus for Measuring Thermal Storage Properties of Phase Change Materials and Products

$28.00 $56.00