• ASTM D5034-09

ASTM D5034-09

Standard Test Method for Breaking Strength and Elongation of Textile Fabrics (Grab Test)

ASTM International, 01/15/2009

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:15/01/2009

Pages:8

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the grab and modified grab test procedures for determining the breaking strength and elongation of most textile fabrics. Provisions are made for wet testing.

1.1.1 The grab test procedure is applicable to woven, nonwoven, and felted fabrics, while the modified grab test procedure is used primarily for woven fabrics.

1.2 This test method is not recommended for glass fabrics, or for knitted fabrics and other textile fabrics which have high stretch (more than 11 %).

Note 1 - For the determination of the breaking force and elongation of textile fabrics using the raveled strip test procedure and the cut strip test procedure, refer to Test Method D 5035.

1.3 This test method provides the values in both inch-pound units and SI units. Inch-pound units is the technically correct name for the customary units used in the United States. SI units is the technically correct name for the system of metric units known as the International System of Units. The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E741-23

ASTM E741-23

Standard Test Method for Determining Air Change in a Single Zone by Means of a Tracer Gas Dilution

$31.00 $63.00

ASTM D2992-22

ASTM D2992-22

Standard Practice for Obtaining Hydrostatic or Pressure Design Basis for “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings

$28.00 $57.00

ASTM D4836-09(2023)

ASTM D4836-09(2023)

Standard Specification for Dipropylene Glycol Monomethyl Ether

$25.00 $50.00

ASTM C987-10(2023)

ASTM C987-10(2023)

Standard Test Method for Vapor Attack on Refractories for Furnace Superstructures

$25.00 $50.00