Your shopping cart is empty!
ASTM International, 05/01/2016
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/05/2016
Pages:3
File Size:1 file , 59 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures used in determining the ash content of adhesives. This standard is intended as a replacement for Method 4032.1 of Federal Test Method Standard 175B, “Adhesives: Methods of Testing.”
1.2 Two test methods are used:
1.2.1 Test Method A is used for a starch adhesive or other type glue, where there is no danger from the non-volatile content forming a rubbery mass when ignited.
1.2.2 Test Method B employs nitric acid to avoid the non-volatile residue being transformed into a viscous foam when ignited.
1.3 These methods are not applicable to adhesives containing decomposable salts such as zinc chloride.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 9.2.3.
Standard Specification for Plastic Insert Fittings For SDR9 Cross-linked Polyethylene (PEX) and Polyethylene of Raised Temperature (PE-RT) Tubing
$31.00 $62.00
Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK)
$30.00 $60.00
Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes
$33.00 $67.00
Standard Practice for Determining the Performance of Oil/Water Separators Subjected to Surface Run-Off