• ASTM D5075-01(2022)

ASTM D5075-01(2022)

Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air

ASTM International, 03/01/2022

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/03/2022

Pages:8

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This test method covers the sampling/analysis of nicotine and 3-ethenylpyridine (3-EP) in indoor air. This test method is based upon the collection of nicotine and 3-EP by adsorption on a sorbent resin, extraction of nicotine and 3-EP from the sorbent resin, and determination by gas chromatography (GC) with nitrogen selective detection (1).2

1.2''The active samplers consist of an macroreticular polystyrene-divinylbenzene copolymer (for example, XAD-4) sorbent tube attached to a sampling pump. Macroreticular polystyrene-divinylbenzene copolymer is referred to '''sorbent resin''' throughout this method. This test method is applicable to personal or area sampling.

1.3''This test method is limited in sample duration by the capacity of the sorbent tube for nicotine (about 300 ''g). This test method has been evaluated up to 24-h sample duration; however, samples are typically acquired for at least 1 h (sometimes only 1 h) (2).

1.4''For this test method, limits of detection (LOD) and quantitation (LOQ) for nicotine at a sampling rate of 1.5 L/min are, respectively, 0.11 ''g/m3 and 0.37 ''g/m 3 for 1-h sample duration and 0.01 ''g/m3 and 0.05 ''g/m3 for 8-h sample duration. The LOD and LOQ for 3-EP at a sampling rate of 1.5 L/min are, respectively, 0.06 ''g/m 3 and 0.19 ''g/m3 for 1-h sample duration and 0.01 ''g/m3 and 0.02 ''g/m3 for 8-h sample duration (2). Both LOD and LOQ can be reduced by increasing the sensitivity of the thermionic specific detector.

1.5''Units'''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary information is given in 13.6.

1.7''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E2751-11

ASTM E2751-11

Standard Practice for Design and Performance of Supported Glass Walkways

$25.00 $50.00

ASTM D976-06(2011)

ASTM D976-06(2011)

Standard Test Method for Calculated Cetane Index of Distillate Fuels

$26.00 $52.00

ASTM A553/A553M-10

ASTM A553/A553M-10

Standard Specification for Pressure Vessel Plates, Alloy Steel, Quenched and Tempered 8 and 9 Percent Nickel

$26.00 $52.00

ASTM E562-11

ASTM E562-11

Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count

$30.00 $60.00