Your shopping cart is empty!
ASTM International, 07/01/2018
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/07/2018
Pages:8
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover procedures for sampling and testing prefabricated, reinforced, polymer-modified bituminous sheet materials designed for single- or multiple-ply application in roofing and waterproofing membranes. These products may use various surfacing materials on one side.
1.2 These test methods cover a number of different products. Not all tests are required for every product. Only those called out in the Product Standard are required.
1.3 These test methods appear in the following order:
Section
Sampling
4
Conditioning
5
Thickness
6
Load Strain Properties
7
Tear Strength
8
Moisture Content
9
Water Absorption
10
Dimensional Stability
11
Low-Temperature Flexibility
12
Heat Conditioning
13
Accelerated Weathering
14
Granule Embedment
15
Compound Stability
16
Coating Thickness
17
Low Temperature Unrolling
18
Precision and Bias
19
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM Book of Standards Volume 2.05: Nonferrous Metal Products: Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products
$111.00 $223.97
Standard Specification for Higher-Strength Martensitic Stainless Steel Plate, Sheet, and Strip
$21.00 $42.00
Standard Test Method for Silicon in Engine Coolant Concentrates by Atomic Absorption Spectroscopy
$27.00 $54.00
Standard Specification for Electric-Resistance-Welded Steel Pipe
$31.00 $62.00