Your shopping cart is empty!
ASTM International, 07/01/2012
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/07/2012
Pages:3
File Size:1 file , 74 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice covers procedures for characterizing fly ash to be used in soil stabilization. This practice lists representative test methods for determining the chemical, physical, and cementitious properties of fly ash. A broad guideline is provided in Appendix X1 that explains the significance of these properties in soil stabilization.
1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.2.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.
1.3 The values stated in SI units are to be regarded as the standard. The inch-pound equivalents are shown for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
1.5 This practice offers a set of instructions for performing one or more specific operations. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this practice may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this document means only that the document has been approved through the ASTM consensus process..
1.6 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
$26.00 $52.00
Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air
$30.00 $60.00
Standard Specification for Age-Hardening Alloy Steel Forgings for Pressure Vessel Components
$24.00 $48.00
Standard Specification for Diesel Fuel Oils
$33.00 $67.00
