Your shopping cart is empty!
ASTM International, 07/01/2017
Publisher: ASTM
File Format: PDF
$34.00$68.00
Published:01/07/2017
Pages:6
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the measurement of extension force developed while drawing a partially oriented filament yarn between pairs of draw rolls of different surface speeds.
1.2 Extension force provides an estimate of the yarn orientation.
1.3 This test method applies to partially oriented filament yarns less than 33.3 tex (300 denier), but it can be used for higher deniers by applying the test conditions as directed in Appendix X1.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM Book of Standards - Volume 05.04: Petroleum Products, Lubricants and Fossil Fuels: Petroleum Products and Lubricants (IV): D6973
$119.00 $238.51
Standard Test Method for Measuring the Soil-Geotextile System Clogging Potential by the Gradient Ratio
$30.00 $60.00
Standard Specification for Ceramic Glazed Structural Clay Facing Tile, Facing Brick, and Solid Masonry Units
$29.00 $58.00
Standard Test Method for Determination for Chemical Oxygen Demand (Manganese III Oxygen Demand) of Water (Withdrawn 2010)