Your shopping cart is empty!
ASTM International, 02/01/2014
Publisher: ASTM
File Format: PDF
$34.00$68.00
Published:01/02/2014
Pages:8
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of electrical conductivity and resistivity of high purity water samples below 10 μS/cm (above 0.1 Mohm-cm). It is applicable to both continuous and periodic measurements but in all cases, the water must be flowing in order to provide representative sampling. Static grab sampling cannot be used for such high purity water. Continuous measurements are made directly in pure water process lines, or in side stream sample lines to enable measurements on high temperature or high pressure samples, or both.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Adhesion of Solid Film Lubricants
$25.00 $50.00
Standard Specification for Ketone Ethylene Ester Based Sheet Roofing
$26.00 $52.00
Standard Test Method for Corrosion Test for Engine Coolants in Glassware
$29.00 $58.00
Standard Test Method for Air Release Properties of Petroleum Oils
$30.00 $60.00