• ASTM D5405/D5405M-98(2011)e1

ASTM D5405/D5405M-98(2011)e1

Standard Test Method for Conducting Time-to-Failure (Creep-Rupture) Tests of Joints Fabricated from Nonbituminous Organic Roof Membrane Material

ASTM International, 05/01/2011

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2011

Pages:5

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers laboratory determination of the time-to-failure (creep-rupture) of joints fabricated from nonbituminous organic roof membrane material. The test method covers both T-peel and lap-shear joints subjected to constant tensile load under controlled environmental conditions. The joints, made from either unreinforced or fabric-reinforced membrane material, are prepared in the laboratory or sampled from roofs in service.

1.2 Sheet materials from which the joints are fabricated include vulcanized rubbers, nonvulcanized polymeric sheets, and thermoplastics. The bonding methods for joint formation include the use of liquid-based adhesives, preformed tapes, and thermal and solvent weld processes.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM C1540-18

ASTM C1540-18

Standard Specification for Heavy-Duty Shielded Couplings Joining Hubless Cast Iron Soil Pipe and Fittings

$30.00 $60.00

ASTM F2030-21

ASTM F2030-21

Standard Specification for Paintball Cylinder Burst Disk Assemblies

$23.00 $46.00

ASTM E285-08(2020)

ASTM E285-08(2020)

Standard Test Method for Oxyacetylene Ablation Testing of Thermal Insulation Materials

$26.00 $52.00

ASTM F1357-99(2009)

ASTM F1357-99(2009)

Standard Specification for Articulating Total Wrist Implants

$29.00 $58.00