• ASTM D5473/D5473M-15

ASTM D5473/D5473M-15

Standard Test Method for (Analytical Procedure for) Analyzing the Effects of Partial Penetration of Control Well and Determining the Horizontal and Vertical Hydraulic Conductivity in a Nonleaky Confined Aquifer

ASTM International, 11/01/2015

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/11/2015

Pages:17

File Size:1 file , 460 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers an analytical solution for determining the horizontal and vertical hydraulic conductivity of an aquifer by analysis of the response of water levels in the aquifer to the discharge from a well that partially penetrates the aquifer. This standard uses data derived from Test Method D4050.

1.2 Limitations-The limitations of the technique for determination of the horizontal and vertical hydraulic conductivity of aquifers are primarily related to the correspondence between the field situation and the simplifying assumption of this test method.

1.3 Units-The values stated in either inch-pound or SI units are to be regarded separately as the standard. The values given in parentheses are for information only.

1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.

1.4.1 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user's objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D412-15a

ASTM D412-15a

Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers-Tension

$33.00 $67.00

ASTM D5125-10(2014)

ASTM D5125-10(2014)

Standard Test Method for Viscosity of Paints and Related Materials by ISO Flow Cups

$31.00 $62.00

ASTM D2290-19

ASTM D2290-19

Standard Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe

$29.00 $58.00

ASTM F1566-99(2004)

ASTM F1566-99(2004)

Standard Test Methods for Evaluation of Innersprings and Boxsprings

$29.00 $58.00